Monster HTUPS 3700 - Manual (Page 22)

14
For safety reasons, the HTUPS 3700 is shipped with the internal battery disconnected . The HTUPS 3700 will not operate
until the internal battery is first connected . Follow these steps to connect or disconnect the battery .
Step One:
Remove the screws on the front panel .
Step Two:
Connect the battery to the internal wire
of the HTUPS .
Step Three:
Re-install the front panel and screws .
IMPORTanT: Before using the HTUPS 3700 for the first
time, charge the battery for at least 4 hours to reach full
charge capacity . Failure to do so may limit the runtime
of the battery .
baTTeRY COnneCTIOn anD RePlaCeMenT InSTRUCTIOnS
battery
Connector