MMD Equipment 40S-8B1 - Manual (Page 49)

5. Periodic Inspection/Maintenance
5-11
5.5.14 Clean inside of the oil fence and check it for any rust
[Every 1 years]
①
Remove the oil filler cap cover, fuel pipes and electric wire connected to the fuel tank.
② Remove 6 pieces of the bolts connecting oil fence and the machine with the lifting eye hooked with
the crane.
③ Lift up the machine to separate the oil fence from the machine.
④ Check and clean the inside of the oil fence.
 Check the inside of the oil fence for dust, fur and other foreign matter and check it for any rust.
 When the oil fence is found rusted, remove the rust outside and inside and paint it again.
 Should any leakage be found, contact your dealer or us directly.
⑤ Check whether the seal rubber attached on the top of oil fence is slanted or curved.
⑥ Combining this machine and the oil fence, tighten the nuts 6 pieces.
⑦ Install oil filler cap cover, fuel pipes and also electric wires.
Combining this machine
and oil fence with the
nuts 6 pieces
Oil fence
Fuel Tank
Oil filler cap cover
[This machine]
Seal rubber
Seal rubber
Connecting to the
electric wire
Connecting to the
fuel pipes
A
A100422
B