beautypg.com

Periodic inspection/maintenance – MMD Equipment 40S-8B1 User Manual

Page 47

background image

5. Periodic Inspection/Maintenance

5-9

A010184

H000049

5.5.9 Change fuel filter

[Every 500 hours]

Take out the cartridge by using a filter wrench.

After coating fuel on the new cartridge“1”packing“2”,
screw it in. (For part number, see 5.4)

When the packing“2”touches the seal face, tighten it by
approximately two-thirds turn using a filter wrench.

Bleed the air of fuel. (See 4.7.6)

After installing a fuel filter, check for fuel leakage during
operation.


5.5.10 Clean outside of radiator

[Every 500 hours]



When the fin tubes“3”of radiator“1”and intercooler

2” are clogged by dust or other foreign materials, the

heat exchange efficiency drops and this will raise coolant
temperature. These tubes and fins should be cleaned
depending on the state of dirt inside the tubes even
before maintenance schedule.



Do not use high pressure washer for washing to prevent

fin tubes“3”from being damaged.



When the unit is used, installed near seaside and on

boat board, clean the radiator using fresh water more
times than once a month.


5.5.11 Check for crack and leak on the exhaust flexible pipe

[Every 4 months or every 500 hours]



Check for any crack and gas leak on the

flexible pipe and exhaust between flexible pipe
between engine exhaust outlet and the flexible
pipe.



If any leak is found, avoid getting burned by

the exhaust gas.


1

Exhaust flexible pipe

Crack

Gas leak

1

2

A100421

This manual is related to the following products: