MMD Equipment 40S-8B1 - Manual (Page 38)

4. Operation
4-17
4.7 Stopping Procedures
① Switch “OFF” the breaker on the operation panel of the generator.
② After performing cooling down operation about 5 minutes, place the starter switch to the“STOP”
position to stop the engine.
③ While the machine is kept unused, keep the operation selector switch placed to the “OFF”position.
4.8 Emergency Stop
 The Emergency Stop button should be used only for emergency stop.
 Regularly check the operating performance.
 If it is necessary to stop the generator for emergency,
press the Emergency Stop button
.
 To reset the button, turn the button head in the
direction of the arrow. If it is not reset, the machine
cannot restart to operate
.
4.9 Air Bleeding
Should the machine stop due to the shortage of fuel, perform the air bleeding operation according to
the following procedures.
① Place the operation selector switch to the “MANUAL” position.
② Place the starter switch to “RUN” position to put electromagnetic pump into operating conditions.
③ Air bleeding will be completed within 20-30 seconds.
④ Place the operation mode selection switch to “LOW” position and start engine.
⑤ Keep warming up operation for 3 minutes after engine has started.
⑥ Then place the operation mode selection switch to “HIGH” position and raise engine speed up to the
rated speed (RPM). Thereafter, repeat mode selection operation “LOW”⇔“HIGH”several times.
H980178
H980179