Microsens MS453522M User Manual
Page 118

MICROSENS 8 Port Gigabit Ethernet Switch
User’s Manual
113
The overview of operation flow for the Fig. 3-52 is quite simple. When Supplicant PAE
issues a request to Authenticator PAE, Authenticator and Supplicant exchanges
authentication message. Then, Authenticator passes the request to RADIUS server to
verify. Finally, RADIUS server replies if the request is granted or denied.
While in the authentication process, the message packets, encapsulated by Extensible
Authentication Protocol over LAN (EAPOL), are exchanged between an authenticator
PAE and a supplicant PAE. The Authenticator exchanges the message to
authentication server using EAP encapsulation. Before successfully authenticating, the
supplicant can only touch the authenticator to perform authentication message
exchange or access the network from the uncontrolled port.
Fig. 3-52
In the Fig. 3-53, this is the typical configuration, a single supplicant, an authenticator and
an authentication server. B and C is in the internal network, D is Authentication server running
RADIUS, switch at the central location acts Authenticator connecting to PC A and A is a PC
outside the controlled port, running Supplicant PAE. In this case, PC A wants to access the
services on device B and C, first, it must exchange the authentication message with the
authenticator on the port it connected via EAPOL packet. The authenticator transfers the
supplicant’s credentials to Authentication server for verification. If success, the authentication
server will notice the authenticator the grant. PC A, then, is allowed to access B and C via the
switch. If there are two switches directly connected together instead of single one, for the link
connecting two switches, it may have to act two port roles at the end of the link: authenticator
and supplicant, because the traffic is bi-directional.
LAN
Authenticator
PAE
Services Offered
by Authenticator
(e.g Bridge Relay)
Authenticator’s System
Authentication
Server’s System
Authentication
Server
Supplicant
PAE
Supplicant’s
System
Uncontrolled port
Controlled port
MAC Enable
Port Authorize