Dixon 1950-2300 Series - Manual (Page 45)

45
Left Rear
Adjuster
Front
Adjusters
CARE AND MAINTENANCE
MOWER DECK LEVELING PROCEDURE
(continued):
D. Turn both outer blades to align with the deck in front-
to-rear manner. Turn left rear adjuster nut up or
down until rear of mower deck is positioned level to
1/8” higher in the rear than the side-to-side
measurement. At this time, the mower deck will be
suspended on (3) points (both front adjusters and the
left rear adjuster). Move the right rear adjuster and
take out the slack which will be present by turning
adjuster locknut up.
E. Confirm measurements once again. Blade tips
should be level in a side-to-side manner. In the rear,
blade tips should be level to 1/8" higher than side-to-
side measurement. In the front, blade tips should be
level to 1/8" lower than side-to-side measurement.
NOTE: This will place the mower deck in a base
measurement position. Additional adjustment may
be required to achieve desired cut for the type of
grass or conditions being mowed.
Deck Leveling Adjustment Points