Care and maintenance, Belts, Belt tension – Dixon 1950-2300 Series User Manual

Page 36

Text mode
Original mode

CARE AND MAINTENANCE

BELTS:

Check belts every 50 hours. Replace any belts found to be
in poor condition.

BELT TENSION:

Engine to Mower Deck Belt:

P/N 6111 (50”)
P/N 6938 (60”)

The engine to mower deck drive belts are automatically
held in proper tension by springs which push the deck
assembly forward and do not require any additional
adjustment to be made.

Mower Deck Serpentine Belt:

P/N 1300 (50”)
P/N 6939 (60”)

Refer to illustration for adjustment procedure.

Idler Weldment

“L” Rod

Idler Shock Mount

Hex Nut

5/8”

Tighten or

loosen hex

nut to

achieve this

demension

Note:

Belt deflection or movement should be approximately 1/4” when
measured at mid-point between pulleys. Periodically inspect both belt
and idler systems.