Metz MECABLITZ 64 AF-1 digital Nikon - Manual (Page 172)

+
automatic unit switch-off is shown in the
INFO display. The flash ready indicator
ቧ and
the indicators on the LC display disappear.
The ቨ button flashes red in stand-by
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
ቨ button, or by tapping on
the shutter release (wake-up function).
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
using the main switch
ባ if it is not going
to be used for an extended period!
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
In all operating modes, the brightness of the
screen is reduced by 50 per cent after
approx. 10 seconds to save energy.
The screen brightness is restored again
whenever a button or a symbol on the screen
is pressed.
D
D
Setting the automatic unit switch-off
• Switch on the flash unit with the
ባ button.
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
• Press the ቨ button as often as it takes
for the selection menu to appear.
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the
touch display.
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
immediately.
The ቨ button flashes red in stand-by
mode.
D
OPTION
STANDBY
STANDBY
D
172
OPTION
OPTION
O
q p
ZOOM MODE
STANDBY
MOD. LIGHT
STANDBY
O
OFF
1 min
10 min
k