Metz MECABLITZ 64 AF-1 digital Nikon - Manual (Page 170)

3.3 Switching the flash unit on and off
• Switch on the flash unit with the ባ
button. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last (e.g.
manual flash mode M).
The ቨ button flashes red in stand-by
mode. To switch off the flash unit, press
the
ባ button until all displays turn off.
If the flash unit will not be used for an
extended period of time, we recommend that
you switch off the flash unit with the
ባ
button and remove the power source (dispo-
sable/rechargeable batteries).
3.4 The selection menu
• Press the
ቨ button as often as it takes
for the selection menu to appear.
The selection menu is divided into 4 sensor
buttons:
The modes of operation can be set after
pressing the
button.
i-TTL*, chap. 7.1
i-TTL BL* , chap. 7.2
A, chap. 7.6
M, chap. 7.3
GN, chap. 7.5
STROBO, chap. 7.7
REMOTE MASTER, chap. 10.1
REMOTE SLAVE, chap. 10.2
SERVO, chap. 10.4
*) only after data exchange with a camera.
D
D
MODE
The flash parameters can be set after
pressing the
button.
P (partial light output), chap.. 7.3; 10.1.3.1
and 10.4.3
EV (exposure correction), chap. 10.1.2.1,
10.1.3.1
ZOOM (reflector setting), chap. 9.1
N (Strobe number of flashes), chap. 7.7
f (Strobe flash frequency), chap. 7.7
GN (Distance guideline), chap. 7.5
F (aperture)
ISO (light sensitivity)
CHANNEL (Channel), chap. 10.2.2
GROUP (slave group), chap. 10.2.3.
The displayed flash parameters are depen-
dent on the selected flash mode.
The touch display can be configured after
pressing the
button, or the flash unit
can be reset to the factory setting.
BRIGHTNESS chap. 15.1
ROTATION chap. 15.2
RESET, chap. 16.3
PARAMETER
SERVICE
170
V 1.2
MB 64AF-1
digital
NIK
MODE
PARAMETER
SERVICE
PARAMETER
O
P / EV
ZOOM
N
f (Hz)
GN
F
ISO
CHANNEL
GROUP
MODE
O
TTL
A
M
GN
STROBO
REMOTE MASTER
REMOTE SLAVE
SERVO
SERVICE
O
BRIGHTNESS
RESET
ROTATION
k