English system call function – Denon AVR-3300 User Manual
Page 35
35
ENGLISH
System call function
• The included remote control unit is equipped with a system call function for transmitting multiple remote control signals when a single button
is pressed (this is often referred to as a “macro” function).
This function can be used to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on a source
component’s power and start playback, etc., all at the touch of a button.
(1) System call buttons
The buttons that can be used for the system call function are shown on the table below.
A series of up to 10 operations can be performed with the POWER ON and OFF buttons, and a series of up to 5 operations can be performed
with other buttons.
System call signals are already preset at the buttons indicated in the shaded section. System call signals can also be stored at any button on
the remote control unit, including the buttons in this section. (See page 36.)
Button
No.
transmissions
Stored
operation 1
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Stored
operation 2
DVD player
(DVD)
power on
LD player
(VDP)
power on
TV power on
Video (VCR)
power on
Receiver
input source
switched to
CD
Stored
operation 3
Receiver
input source
switched to
DVD
Receiver
input source
switched to
VDP
Receiver
input source
switched to
TV/DBS
Receiver
input source
switched to
VCR-1
Stored
operation 4
TV power on
TV power on
TV power on
Stored
operation 5
Stored
operation 6
Stored
operation 7
Stored
operation 8
Stored
operation 9
Stored
operation 10
DVD player
(DVD)
playback
LD player
(VDP)
playback
Video (VCR)
playback
POWER OFF
10
POWER ON
10
DVD
5
VDP
TV/DBS
VCR-1
CD
5
5
5
5
The system call signals for the POWER OFF and
POWER ON buttons are transmitted from the
remote control unit approximately once every
second.
The signals for the other buttons (DVD, VDP, TV /
DBS, VCR-1 and CD) are transmitted approximately
once every 1.5 seconds.
(2) Using the system call function
1
Press the system call button.
• The LEARNED/TX LED flashes for 5 seconds.
CALL
2
Press the button at which the desired system call signals are
stored while the LEARNED/TX LED is flashing.
• The preset signals or the signals you have stored at that
button are transmitted in succession.
DVD
START
LEARNED/TX
SPEAKER
TUNING
BAND
TITLE
MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE
MULTI
OUTPUT
SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS
SURROUND
DIRECT
DSP SIMULATION
5CH STEREO
STEREO
INPUT MODE
ANALOG
EXT.IN
MUTING
MASTER VOL.
VOLUME
DISC SKIP+
SYSTEM CALL
POWER
VDP
TUNER
SHIFT
TV/DBS
PHONO
VCR-1
CD
MD / TAPE
CHANNEL
VCR-2/V.AUX
TV/VCR
AVR/AVC
VIDEO
DVD
TV
AUDIO
VDP
VCR
CD
MD
MULTI
DECK
SYSTEM
SETUP
SURROUND
PARAMETER
CH SELECT
SELECT
RC-860
1
2
3
4
SET
A / B
CALL
OFF
ENTER
ON / SOURCE
5
6
7
8
9
+10
0
2
1