Metro TC90S/B Insulated Cabinet User Manual
Page 10

9
1. Remove the screw retaining the
bulb to the inner liner.
2. With control panel
disconnected, remove the
grommet in the cabinet inner
liner and carefully push the
thermostat bulb through
the hole in the cabinet side.
Replace grommet with part
number RPC07-044 and
thermostat with part number
RPC13-113. Attach wires to
correct terminals.
3. Carefully uncoil new tubing
and bulb and feed through the
bushing in the cabinet side.
CAUTION: DO NOT make
sharp bends or kinks in the
capillary tubing.
4. Replace control panel being
careful not to pinch the
capillary. Also, coil the unused
portion of the capillary tube
near the top of the control panel
BEING CAREFUL TO KEEP
THE TUBE CLEAR OF ANY
ELECTRICAL TERMINALS.
5. Seal the hole around the
capillary tubing in the inside of
the cabinet with a FDA grade
silicone sealant.
8. Power Cord
1. Uncoil cord and remove
complete control panel. Refer
to Complete Control Panel.
2. Remove strain relief.
3. Note and record wire locations
on terminal block and
grounding stud.
4. Remove damaged cord and
replace with part number
RPC13-108.
9. Strain Relief
1. Using pliers, squeeze the strain
relief from the inside and push
it out through the mounting
hole. Replace with part number
RPC13-110.
2. Install new relief onto the
cord, squeeze and insert into
mounting hole. Be certain that
the fl ats on the relief match the
fl ats on the hole.
PARTS TO BE REPLACED
REPLACEMENT PROCEDURE
10. Travel Latch
1. Remove control panel. See
Complete Control Panel page
8.
2. Remove hardware retaining
latch and replace with part
number RPC09-028.
11. Kick Latch
1. Remove control panel. Refer to
Complete Control Panel page
8.
2. Remove cotter pin and clevis
pin. Replace kick latch with
part number RPC09-027.
12. Magnetic
1. Remove control panel. Refer to
13.
Door Latch
Complete Control Panel page 8.
2. Remove old latch by pinching
the top and bottom of the
magnet housing from the inside
of the control panel. Push the
part out through the front.
3. Replace with part number
RPC14-041 by inserting from
front of control panel.
4. Replace control panel.
13. Kick Latch
1. Remove cotter pin.
14.
Spring 2. Remove clevis pin.
3. Replace spring with part
number RPC10-013.
14. Cotter Pin
1. Replace with part number
RPF07-066.
15. Clevis Pin
1. Replace with part number
RPF05-017.
PARTS TO BE REPLACED
REPLACEMENT PROCEDURE