Denon AVR-1611 - Manual (Page 37)

34
ENGLISH
Convenient functions
Quick select function
All of the settings in step 1 can be memorized together. By memorizing
frequently used settings, you can quickly access and enjoy a playback
environment that is consistently the same.
n Saving the settings
1 Set the items below to the settings you want to save.
q Input source (vpage 19)
w Volume (vpage 20)
e Surround mode (vpage 24)
r Video Select (vpage 42)
t Audyssey Setting
(MultEQ®, Dynamic EQ®, Dynamic
Volume®) (vpage 46)
2 Press and hold the desired QUICK SELECT until
“Memory” appears on the display.
The current settings will be memorized.
G Quick Select DefaultsH
Input Source Volume
QUICK SELECT 1 BD –40 dB
QUICK SELECT 2 SAT/CBL –40 dB
QUICK SELECT 3 DOCK –40 dB
n Recalling the settings
Press QUICK SELECT at which the
settings you want to call out are saved.
The , or indicator illuminates on
the display.
Naming quick select settings
See “Quick Select Name” (vpage 54).
• The Quick Select function can be set separately for the different
zones (vpage 35 “Quick select function”).
• If QUICK SELECT on the main unit
is pressed, the same function as
with the remote control unit can be
obtained.
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at “Source Delete” (vpage 53). In this case,
store them again.
Various memory functions
n Personal memory plus function
This function sets the settings (input mode, surround mode, HDMI
output mode, MultEQ, Dynamic EQ, Dynamic Volume, audio delay
etc.) last selected for the individual input sources.
The surround parameters, tone settings and the volumes of the
different speakers are stored for the individual surround modes.
n Last function memory
This function stores the settings which were made before going
into the standby mode.
When the power is turned back on, the settings are restored.
Playback in ZONE2
(Separate room)
• You can operate this unit so as to enjoy audio in a different room
(ZONE2) other than the MAIN ZONE (room where the unit is located).
• You can simultaneously play back the same source in both the MAIN
ZONE and ZONE2. You can also play back separate sources in the
MAIN ZONE and ZONE2.
Audio output
ZONE2 playback by speaker output
The ZONE2 audio signals are output from this unit’s SURR. BACK/
AMP ASSIGN speaker terminals using the amplifier assignment
function.
n Connecting and setting the speakers
“Amp Assign” setting
(vpage 49) and audio
signals output
Connecting the speakers
ZONE2
Output signal :
Stereo (L / R)
MAIN ZONE
ZONE2
This unit
We recommend using high quality pin-plug cables for audio
connections in order to prevent noise.
NOTE
It is not possible to play the digital audio signals input from the HDMI,
COAXIAL or OPTICAL connectors in ZONE2.