Denso BHT-400B-CE - Manual (Page 136)

This key is provided automatically:
Select this check box to automatically obtain the network key.
Enable 802.1X authentication:
Select this check box to enable 802.1X authentication.
EAP type:
Select the “Enable 802.1X authentication” checkbox to enable
selection.
Refer to “Settings when PEAP, TLS Selected for EAP Type” on
the following page for further details.
• Security and Setting Method
The security level can be changed based on combinations of the encryption and authentication. The
setting parameters for each security level are shown in the table below.
Security
Setting
parameter None
PEAP
(802.1x)
EAP-TLS
(802.1x)
PEAP
(WPA)
EAP-TLS
(WPA)
PSK
(WPA)
Encryption Disabled WEP WEP WEP TKIP TKIP TKIP
Authentication – Open Open Open WPA WPA WPA-PSK
Network key – xxxxxx – – – – xxxxxx
Key index – 1 to 4 – – – – –
The key is
provided
automatically
– * √ √ – – –
Enable 802.1X
authentication
– * √ √ – – –
EAP type – – PEAP TLS PEAP TLS Ignored
(Note)
– : No entry possible
√ : Select
* : No entry or no selection
xxxxxx : Enter the network key.
116