Meinberg PZF511 - Manual (Page 12)

12
Menu SYNTH.
The output frequency of the internal synthesizer is selected in this menu. This can be
done in the range of 1/3Hz to 9.999MHz.
The frequency can be set here and the buttons are used the same way as for setting the
DIST.o.T-value. In addition, the range of the frequency is defined and eiter xxx.xHz,
x.xxxkHz, xx.xxkHz, xxx.xkHz or x.xxxMHz can be selected. In the first range (Hz)
only the fractional digits 1/3Hz, 0.5Hz and 2/3Hz are accepted. After the frequency is
entered the value becomes valid and is stored in the battery buffered RAM just after the
Menu-button is pressed a longer time. Note: the sinewave output of the synthesizer
provides an acceptable output signal not above 100kHz.
Menu SYNTH M.
This menu configueres at which time after power-up the frequency generation of the
synthesizer starts. The following settings are possible:Frequency-generation immediate-
ly after reset (allways),
or the clock has to synchronize first before generation of the frequency starts (after
synchronisation). Frequencies less than 10kHz are phase locked to the precise pulse per
second at once.
Selection of the values happens like described.
Menu TIME REF
The displayed timezone can be set in this menu. Possible selections are:: UTC, MEZ/
MESZ and MEZ (without daylight saving).