Daewoo SD-2100P - Manual (Page 23)

22
2nd scart socket
2nd scart socket
If your video has the AV2 output, shown in the diagram below, you can connect other equipment as seen on pages
17-20.
2nd scart
INPUT ONLY
INPUT+OUTPUT
When connecting other equipment please refer to their manuals for further information. This video manual
recommends the set up as shown on page 17. When connected by this method if the equipment is turned off the
video behaves as normal, but if the equipment is turned on the video will automatically switch over to AV2 mode
and displays the channel of the other equipment, channel selection can only be performed by the other equipment,
the video PR+/PR- buttons have no effect.
To return to normal video use the other equipment must be turned off.
Recording from other Equipment.
Simple recording can be performed, ensure the equipment is turned on and is displaying the correct channel.
Timer recording, set the video to perform a timed recording ensuring AV1 is selected as the channel to be recorded.
Some equipment may have a timer which allows it to be powered on to the correct channel, if this feature is not
available the other equipment should be left powered on.
Front AV
If the video has front input sockets, it is possible to connect devices such as a
camcorder to the video. To watch a camcorder tape the video must be in AVF
mode. Recordings of this input are the same as described on page 20.
DV6T711P-AP(DESUK)1 02.7.24 11:16 AM ˘ ` 22 mac001 300DPI 120LPI