beautypg.com

3hardware installation – Measurement Computing PPIO-AI08 User Manual

Page 6

background image

3

HARDWARE INSTALLATION

The PPIO-AI08 has one bank of switches which controls the analog input voltage
range of the board. The switches are accessible by removing the cover of the
PPIO-AI08. The switch settings and ranges are printed on the board. The PPIO-AI08
is shipped in the ±5V range. The other ranges are ±10V and 0 to 10V.

3.1

RANGE /GAIN SWITCH SETTING

The PPIO-AI08 is factory set to ± 5V. If you want to change to ± 10V or 0 to 10V,
then:

1. Remove the cover of your PPIO-AI08 by removing the four corner screws. Be

careful not to loose the rubber spacers.

The bank of dip switches on the PPIO-AI08 control the UNIPOLAR/BIPOLAR

setting and the Input Range. There are four dip switches which must be set to select
a specific input range for the analog inputs.

2. Use the table below to determine the correct positions of switches S1 through S4

for the range or gain you require.

These switches set the analog input range of all eight channels simultaneously.

2.44mV /

BIT

0 to 10V

1

D

U

U

D

4.88mV /

BIT

±10

0.5

U

D

D

U

2.44mV /

BIT

±5V

1

U

D

U

D

RESOLUTION

RANGE

GAIN

S4

S3

S2

S1

D = Down, U = Up. Positions other than those shown are not valid.

3.2

CONNECTING THE PPIO-AI08 TO A DESKTOP COMPUTER

1. Turn the power off.

2. Remove the cover of your computer. Please be careful not to dislodge any of the

cables installed on the boards in your computer as you slide the cover off.

3. Run the

PPIO

power cable into the computer through one of the

COM

accessory

panel holes in the back of the

PC.

4. Connect the

PPIO

power cable to one of the spare accessory power connectors in

the

PC.

These are the white plastic power connectors that are used to power disk

drives. There should be a few spare in your computer.

2