Measurement Computing Micro488/p - Manual (Page 8)

1-2 09-26-02 Micro488/p, Introduction
1.3 Specifications
IEEE 488-1978
Implementation: C1, C2, C3, C4 and C28 controller subsets.
Terminators: Selectable CR, LF, LF-CR and CR-LF with EOI.
Connector: Standard IEEE 488 connector with metric studs.
Serial Interface
EIA RS-232C: AB, BA, BB, CA, CB.
Character Set: Asynchronous bit serial.
Output Voltage: 5 volts min. (RS-232C).
Input Voltage: 3 volts min.; 15v max.
Baud Rate: Selectable 300, 1200, 2400, 4800, 9600, and 19200.
Data Format: 8 data bits; 1 or 2 stop bits, no parity.
Duplex: Full with Echo/No Echo.
Serial Control: Selectable CTS/RTS or XON/XOFF.
Terminators: Selectable CR, LF, LF-CR and CR-LF.
Connector: 25-pin Sub-D male. RS-232C DCE Configured.
General
Data Buffer: 120 character input buffer.
Power: Draws less than 5mA from the DTR or DSR serial lines on the
host computer.
Max. Dimensions: 50mm x 60mm x 25mm (2" x 2.3" x 0.9").
Weight: 51.2 grams (1.8 oz).
Environment: 0 ° to 50°C; 0 to 90% R.H. non-condensing.
Controls: All settings auto or software configurable.
Note: Specifications subject to change without notice.