Measurement Computing Micro488/p - Manual (Page 19)

Command Descriptions 09-27-02 3-1
Command Descriptions
3.1 Introduction
This section contains detailed descriptions of each of the low and high-level
commands available for the Micro488/p. There are two types of commands: bus
commands and system commands. Bus commands communicate with the IEEE 488
bus. System commands configure or request information from the Micro488/p.
Bus Commands:
A (ABORT I/O)
C (DEVICE CLEAR)
C; (DEVICE CLEAR w/device specified)
EO;n (EOI ENABLE/DISABLE)
EN (ENTER)
EN; (ENTER w/device specified)
L (LOCAL)
L; (LOCAL w/device specified)
LL (LOCAL LOCKOUT)
O;cmd$ (OUTPUT)
OA;;cmd$ (OUTPUT w/device specified )
RE (REMOTE)
RE; (REMOTE w/device specified)
RS (RESUME)
SP;; (SERIAL POLL)
SQ (SRQ CHECK)
TR (TRIGGER)
TR; (TRIGGER w/device specified)
/A (LOW-LEVEL COMMAND)
/L; (SEND LISTEN ADDRESS w/device specified)
/ML (LOW-LEVEL COMMAND)
/MT (LOW-LEVEL COMMAND)
/T; (SEND TALK ADDRESS w/device specified)
/UL (LOW-LEVEL COMMAND)
/UT (LOW-LEVEL COMMAND)