Measurement Computing USB-DIO96H-50 - Manual (Page 15)

USB-DIO96H/50 User's Guide Specifications
15
Power
Table 2. Power specifications
Parameter Conditions Specification
USB +5 V input voltage range 4.75 V min to 5.25 V max
USB +5 V supply current All modes of operation <100 mA
External power input (Note 1) 5 VDC ± 5% (5 VDC power supply
provided)
External power supply
(included) MCC p/n PS-5V3AEPS 5 VDC, 15 W, 5% regulation
Alternate external power
supply From PC auxiliary power (cable not
included) Jumper selectable Molex ® connector
internal to case
Voltage supervisor limits 4.13 V > V
ext
or V
ext
> 5.59 V PWR LED = Off (power fault)
4.13 V < V
ext
< 5.59 V PWR LED = On
Power supply current 2.7 A max
User 5 V output voltage range Available at +5 V pins 4.0 V min, 5.25 V max
User 5 V output current
available Total from all +5 V pins 50 mA max
Note 1: Voltage specification applies at barrel plug power input. The power supply provided with the board
meets this specification at the rated total power supply current. If a different power supply is used,
small line resistances could cause significant voltage drop between the power supply and the barrel
plug input.
Environmental
Table 3. Environmental specifications
Parameter Specification
Operating temperature range 0 °C to 60 °C
Storage temperature range –40 °C to 85 °C
Humidity 0% to 90% non-condensing
USB specifications
Table 4. USB specifications
Parameter Specification
USB "B" connector Input
USB device type USB 2.0 (full-speed)
Device compatibility USB 1.1, USB 2.0
USB cable type A-B cable, UL type AWM 2527 or equivalent. (min 24 AWG VBUS/GND, min 28 AWG
D+/D–)
USB cable length 3 m (9.84 ft) max
Data transfer rates
Table 5. Data transfer rate specifications
Parameter Specification
Digital I/O transfer rates
(software paced) System-dependent, 33 to 250 port reads/writes or single bit reads/writes per second typ