Signal connections – Measurement Computing PCI-DDA02/12 User Manual
Page 7
PCI-DDA02/12 User's Guide
Installing the PCI-DDA02/12
7
Complete the following steps to install the board:
1. Turn your computer off, open it up, and insert your board into an available PCI slot.
2. Close your computer and turn it on.
When you connect the device for the first time to a computer running Windows, a
Found New Hardware
dialog opens when the operating system detects the device. If the information file for this board is not
already loaded onto your PC, you will be prompted for the disk containing this file. The MCC DAQ
software contains this file. If required, insert the Measurement Computing Data Acquisition Software CD
and click
OK
.
3. To test your installation and configure your board, run the InstaCal utility you installed in the previous
section. Refer to the Quick Start Guide that came with your board
for information on how to initially set up and load InstaCal.
Signal connections
The table below lists the board connectors, applicable cables and compatible accessory boards.
Connector type
100-pin, high density connector
Compatible cables
C100FF-x unshielded ribbon cable (x = length in feet)
Compatible accessory products with
the C100FF-x cable
SCB-50
CIO-TERM100
CIO-MINI50 (two required)