Measurement Computing PCI-DDA02/12 - Manual (Page 6)

6
Chapter 2
Installing the PCI-DDA02/12
What comes with your shipment?
Verify that the following components are included in the shipment:
Hardware
 PCI-DDA02/12
Software
 MCC DAQ CD
Documentation
In addition to this hardware user's guide, you should also receive the Quick Start Guide. This booklet provides
an overview of the MCC DAQ software you received with the device, and includes information about installing
the software. Please read this booklet completely before installing any software or hardware.
Optional components
 C100FF-x cable
 Signal termination boards
Measurement Computing provides signal termination boards for use with the PCI-DDA02/12. Refer to
Signal termination on page 9 for more information.
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the PCI-DDA02/12 from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, notify Measurement Computing Corporation immediately by
phone, fax, or e-mail:
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
web site at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
Installing the hardware
The PCI-DDA02/12 board is completely plug-and-play. There are no switches or jumpers to set. Configuration
is controlled by your system's BIOS.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install the
MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on installing
the software.