Measurement Computing PCI-DAS-TC - Manual (Page 16)

PCI-DAS-TC User's Guide Specifications
16
Table 3. Thermocouple measurements (not including CJC errors)
TC
Type Range Accuracy (Worst Case) Resolution
@ 50 Hz @ 60 Hz @ 400 Hz
J 0 to 750 °C ±0.5 °C 0.05 °C 0.05 °C 0.40 °C
K 200 to 1250 °C ±1.4 °C 0.04 °C 0.05 °C 0.40°C
E 200 to 900 °C ±1.1 °C 0.03 °C 0.04 °C 0.25 °C
T 200 to 350 °C ±0.9 °C 0.03 °C 0.04 °C 0.25 °C
R 0 to 1450 °C ±2.3 °C 0.06 °C 0.07 °C 0.44 °C
S 0 to 1450 °C ±2.3 °C 0.06 °C 0.08 °C 0.52 °C
B 0 to 1700 °C ±3.0 °C 0.07 °C 0.08 °C 0.54 °C
Miscellaneous
Table 4. Miscellaneous specifications
Averaging Moving average, 1 to 16 samples, software-selectable
Calibration Calibration is performed with each channel scan to remove offset and gain error. CJC
channel is also measured with each calibration.
Processor reset On power-up, watchdog timeout, or software command. Processor boots within one
second of reset. Active low.
Watchdog timer 1.6 seconds nominal. Processor generates watchdog disable signal after boot-up.
Temperature units Programmable for conversion to C or F
Interrupts INTA# mapped to IRQn by PCIBIOS at boot time
Interrupt enable Programmable
Interrupt sources Dual port RAM when the processor mailbox has data.
Crystal oscillator
Table 5. Crystal oscillator specifications
Frequency 32 MHz
Frequency accuracy 100 ppm
CIO-STA-TC adapter
Table 6. CIO-STA-TC adapter specifications
CJC type AD592CN
Configuration CJC centered in an isothermal block on which the screw terminals have been mounted.
Channels 16 (plus CJC output)
Calibration error
Table 7. Calibration error specifications
@ 25 °C 0.3 °C typical, 0.5 °C maximum
25 °C to +105 °C 0.5 °C typical, 1.0 °C maximum