Measurement Computing PCI-DAS1602/16 - Manual (Page 11)

PCI-DAS1602/16 User's Guide Installing the PCI-DAS1602/16
10
Connecting the board for I/O operations
Connectors, cables – main I/O connector
The table below lists the board connectors, applicable cables, and compatible accessory products for the PCI-
DAS1602/16.
Board connector, cables, and accessory equipment
Connector type 100-pin high-density Robinson-Nugent
Compatible cables C100FF-x
Compatible accessory
products with the
C100FF-x cable ISO-RACK16/P
ISO-DA02/P
BNC-16SE
BNC-16DI
CIO-MINI50
CIO-TERM100 SCB-50
SSR-RACK24 (DADP-5037 adaptor required)
SSR-RACK08 (DADP-5037 with TN-MC78M05CT adaptor required)
CIO-ERB24 (DADP-5037 adaptor required)
CIO-ERB08 (DADP-5037 adaptor required)
CIO-SERB08 (DADP-5037 adaptor required)
The PCI-DAS1602/16 board's main I/O connector is a 100-pin high density connector labeled J1 . All signals
pass through this connector. The pinout for eight-channel differential mode is shown on page 11. The pinout for
16-channel single ended mode is shown on page 12.
Information on signal connections
General information regarding signal connection and configuration is available in the Guide to Signal
Connections (available at
www.mccdaq.com/signals/signals.pdf) .
Caution! When connecting a cable to the board's I/O connector, make sure that the arrow indicating pin 1
on the board connector lines up with the arrow indicating pin 1 on the cable connector.
Connecting cables can damage the board and the I/O controller.