Specifications, Analog input, Chapter 4 – Measurement Computing PCI-DAS1002 User Manual
Page 18

18
Chapter 4
Specifications
Typical for 25 °C unless otherwise specified.
Specifications in italic text are guaranteed by design.
Analog input
Table 1. Analog input specifications
Parameter
Specification
A/D converter type
ADS7800 or equivalent
Resolution
12 bits
Number of channels
16 single-ended / 8 differential, software selectable
Input ranges
±10 V, ±5 V, ±2.5 V, ±1.25 V, 0 to 10 V, 0 to 5V, 0 to 2.5 V, 0 to 1.25 V software
programmable
A/D pacing
(software programmable)
Internal counter - 82C54.
External source (A/D External Pacer)
software programmable for rising or falling edge
Software polled
A/D trigger sources
External edge trigger (A/D EXTERNAL TRIGGER)
A/D triggering modes
Rising edge trigger
A/D pre-trigger mode
Unlimited pre- and post-trigger samples. Total number of samples must be greater than
512.
Burst mode
Software selectable option, burst rate = 150 kHz
Data transfer
From 1024 sample FIFO via REPINSW
Programmed I/O
A/D conversion time
3 µs max
Analog front end settling time
6 µs for a full scale step to 1 LSB
Calibrated throughput
200 kHz
Calibration
Auto-calibration, calibration factors for each range stored on board in nonvolatile RAM
A/D full-scale gain drift
±0.25 LSB/°C max
A/D zero drift
±0.25 LSB/°C max
Common mode range
±10 V min
CMRR @ 60 Hz
-70 dB min
Input leakage current
±20 nA max
Input impedance
10 MOhms min
Absolute maximum input
voltage
±35 volts
Warm-up time
15 minutes