MEGA Corp. MHT175-CAT777-OPS-1 - Manual (Page 36)

MHT175-CAT777(G)-1
1 Aug 2012
SECTION 6
Appendix
6-10
MHT175-CAT777(G)CL-1
1 Aug 2012
9. If there is any hesitation passing through the float
position, the operator must reopen the doors
slightly and close them again without hesitation.
10. Continue safely back to the pit driving appropriate
to the road conditions.
AFTER OPERATIONS
These procedures are used to perform a walk-around
inspection after using the MHT175-CAT777(G)
system. This inspection is in addition to and does not
replace the CAT 777(G) inspection requirements.
1. Transmission Control Lever – P (Park)
2. Vehicle Engine – AS REQUIRED
3. Hoist Control Lever – HOLD
4. Turn Limit Indicator
– CHECKED FOR
DAMAGE AND SECURITY
5. Upper Deck Assembly – CHECKED FOR
DAMAGE AND SECURITY
N-9