MBM Corporation 352S - Manual (Page 16)

Operator's Manual multipli 35 Friction Feeder F35
Mathias Bäuerle GmbH 19
Setting the Sheet
Separation
!
Exercise caution in the vicinity of rotating shafts and rollers!
Hair, loose garments and jewellery may get caught!
SERIOUS INJURY MAY RESULT!
• Switch on the machine - knob (1) in
position I.
• Move the feeder until it audibly engages
in the rest position (2).
• Push open the setting disk (3) and turn it
counter-clockwise by about one turn.
This lowers the pressure roller. The gap
between feed- and pressure roller is increased.
• Slide an unfolded sheet between feed- and
pressure roller and hold it tight (4). 1
2
3
4
5
Hold on to the sheet to avoid that it is gripped by the feed roller
and then folded.
• Keep the sample sheet in this position and use your other hand to slowly turn the
setting disk (3) clockwise until you feel a slight resistance when pulling back the
sheet. The gap between feed- and pressure roller is now set to the thickness of the
sheets to be folded. Now remove the sample sheet.
• Switch off the machine - knob (1) in position 0.
• Place the setting disk (3) back in rest position to avoid accidental movement.
Corrections can be made with the machine running.
• Loosen the knurled nut (5) at the feeder.
By changing the location of the knurled nut the contact pressure at the feeder can
be set to the type of paper:
Light grades of paper (below 60 GSM):
Only light pressure necessary, push in
direction of the delivery section.
Medium weight papers (60 to 90 GSM):
The weight of the feeder itself is sufficient,
neutral mid-position.
Heavy paper grades (more than 90 GSM):
Higher pressure needed, push in direction
of feed section.