MBM Corporation iCREASE AIR - Manual (Page 4)

SAFETY PROCEDURES
BEFORE USE:
• Read through the owner’s manual. Follow instructions CAREFULLY.
• NEVER use a wet area. Electric shock could occur.
• Use a GROUNDED outlet and a GROUNDED circuit. Do no use ungrounded
equipment on the same circuit.
• Always use a dedicated line. DO NOT use with line splitting surge protector.
DURING USE:
• Keep fingers and hands away from creasing bar, perf blades, and rubber
rollers.
• Keep cords clear of moving parts.
AFTER USE:
• Turn off machine at the top panel, then unplug the main power cord. This
will prevent damage to your machine by power/voltage spikes.
• To unplug cords, always grasp the plug body, never pull on cords to
disconnect. Wire fatigue and possible shock could result from improper
disconnect procedures.
BE ALERT! BE CAREFUL!
CARE AND MAINTENANCE
The icreaseAIR is a precision machine. It is very important to keep it free of excessive
dust, dirt and foreign matter. We recommend that you keep the machine
covered
when not in use.
BEARINGS/BUSHINGS: The bearings are sealed roller bearings and are designed to
be self lubricating, however dirt and dust can get into them causing clogging and dirt
build up. It is recommended to oil them daily under heavy use or monthly under light
use. The Bushings are Bronze and require lubrication more frequently. Oil these once a
week under heavy use.
STRIKE DIE: The groove in the lower die should be cleaned periodically using a
toothbrush to remove any dirt or build up.
SENSOR EYE: Clean the lower reflector tape located on the plate under the strike plate
of the machine. Dust will cause the beam to not reflect correctly. Clean when
necessary.
REMOVEABLE SCREWS: When these show signs of wear or stripping, replace as soon
as possible. If these strip or hollow out they can be costly to remove. If you do keep
your icreaseAIR clean and in top condition, it will give you years of service.
1b