MBM Corporation iCREASE AIR - Manual (Page 33)

ADJUSTING THE RAC ROLLERS
The RAC rollers are set from the factory and it is NOT recommended to make any
adjustments to this without consulting with MBM’s tech-support department.
Should an adjustment be necessary, please follow the steps below.
Loosen the small bearing block lock screws. This allows very slight adjustments of the
bearing block to be made by loosening the thumb lock and turning the height
adjustment screw in the middle of the bearing block. This is a very fine thread and is
capable of making very slight adjustments. Turning the adjustment screw clockwise will
increase the bar pressure, as counterclockwise will decrease the pressure. Once the
adjustment to the bar has been made, slightly tighten the thumb lock and re-set the
block set-screws.
CHANGING THE LOWER CREASE DIE
The Lower crease die can easily be changed to accommodate thicker stocks by removing
the non-operator side cover, slide the bar out and flip it over to use the wider die
channel. Please note, custom die’s are available upon request.
30