MBM Corporation AEROCUT NANO - Manual (Page 3)

AeroCut nano OPERATION MANUAL
3
3. Don't touch the blade point of the cutter. There is a danger of receiving an injury.
4. Turn off the power supply beforehand when setting the feed table. There is a danger of
receiving an injury.
5. Turn off the power supply beforehand when removing paper scraps. There is a danger of
receiving an injury.
6. Do not exceed the MAX level when stacking the paper. Exceeding it may cause a
mechanical failure.
7. Turn off the power supply beforehand when starting maintenance or inspection. There is a
danger of receiving an injury.
8. When you install a machine, please install to a place with no dust, and the place which is
not influenced with a liquid. It becomes the cause of failure if the installation method is
mistaken.
9. When you put a machine into operation, please change into the state where all covers
were closed. If it works where a cover is opened, there is fear of an injury.
Before use
Read this "Operation Manual" carefully before use. In particular, be sure to read "Safety
Instructions" (page 2 to page 3) to ensure that the machine will be used properly.
Keep the manual at an appointed place with care so that it may be accessible whenever
necessary.
The specifications of this product are subject to change for improvement. Therefore, don't
mistake the "Operation Manual" of one product of the same model for that of another
because descriptions in the "Operation Manual" of products of the same model may differ.