MBM Corporation AEROCUT NANO - Manual (Page 26)

AeroCut nano OPERATION MANUAL
26
12. Final cutting measurement error
Correct the final cutting measurement to
exceed the value specified below.
13. Leading edge margin and cut mark
margin warning
Correct the measurement so that the
leading margin becomes larger than the
cut mark margin.
14. Cutting measurement error
Correct the cutting measurement to fit in
the value range below.
The maximum value is subject to
change depending on the entered paper
size.
15 Cut piece number error
Correct the number of cut pieces to be
in the value range below.
The maximum number of pieces is
subject to change depending on the
operation.