Set up speakers, To 5 for “set up “amp assign, Steps 3 to 5 for “set up “amp assign – Marantz SR7007 User Manual
Page 94: Set up the remote control unit, Press zone select, Set up “amp assign
91
1
Set up the
remote control unit
n Set up the zone mode
Press
ZONE SELECT
to switch “MAIN”.
Press ZONE SELECT
NOTE
When using a remote control with preset codes registered
(
), press
AVR
to set the remote control to the AVR-
operation mode before operation.
2
Connect the setup microphone.
Audyssey Setup
Amp Assign
Channel Select
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the setup microphone is
connected, the following screen is
displayed.
Set up speakers
around items indicate the settings.
This section describes detailed settings for Audyssey® Setup.
First install and connect the speakers to this unit.
Before Audyssey® Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (
3
Set up “Amp Assign”
Use
ui
to select “Amp Assign”, and then press
ENTER
.
Amp Assign
Assign Mode
Main Only
ZONE2:
Selects how to use the internal amplifiers
ZONE3:
Audyssey Setup
Amp Assign
Channel Select
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
4
Select “Assign Mode”, and then press
ENTER
.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
v See overleaf
DVD