Marantz SR6009 User Manual
Page 224
Symptom
Cause / Solution
Page
Dolby PLg mode or DTS
Neo:X mode cannot be
selected.
0
It cannot be selected when “Speaker Config.” - “Center” or “Surround” is set for “None”.
0
Dolby PLg or DTS Neo:X cannot be selected when using the headphones.
－
Audyssey MultEQ
®
XT,
Audyssey Dynamic EQ
®
and Audyssey Dynamic
Volume
®
cannot be
selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
0
These cannot be selected when using the headphones.
－
Audyssey DSX
®
cannot be
selected.
0
It can be selected when using the front height or front wide speakers.
0
It can be selected when using the center speaker.
0
Switch the sound mode to Dolby sound mode or DTS sound mode.
0
This cannot be selected when using the headphones.
－
0
This cannot be selected when an HD audio format with a sampling frequency of over 96 kHz is input
(such as may be found on select Dolby TrueHD and DTS-HD discs).
－
“M-DAX” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
No audio is output from
PRE OUT or speakers for
ZONE2.
0
In ZONE2, the audio can be played back when signals input from digital connectors (OPTICAL/
COAXIAL) are in 2ch PCM format.
－
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
format. To play back the audio in ZONE2 irrespective of the input signal format, set the “HDMI Audio”
setting in the menu to “PCM”. Depending on the played back device, the audio may not be played back
even with this setting. In that case, set the audio format to “PCM (2ch)” on the played back device.
0
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 10 m.
－
224