Marantz SR6009 - Manual (Page 206)

ZONE2 Setup
Configure the settings for audio playback on ZONE2.
Values set for “Volume Limit” and “Power On Volume” are displayed according to the
setting specified for the volume “Scale”. (v p. 157)
o Bass
Adjust bass.
-10 dB – +10 dB (Default : 0 dB)
o Treble
Adjust treble.
-10 dB – +10 dB (Default : 0 dB)
o High Pass Filter
Make settings for cutting the low range to reduce distortion in the bass.
On: The low range is attenuated.
Off
(Default):
The low range is not attenuated.
o Lch Level
Adjust the left channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Rch Level
Adjust the right channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Channel
Set whether to playback in stereo or monaural.
Stereo
(Default):
Stereo playback.
Mono: Monaural playback.
o HDMI Audio
Selects the audio signal format for playing an HDMI source in ZONE2.
Through
(Default):
The HDMI audio signal is passed through this unit to the
device in ZONE2.
PCM:
The HDMI audio signal input into this unit is converted to a
PCM signal that can be output from the ZONE2 PRE OUT
terminals or speaker terminals.
Contents Connections Playback Settings Tips Appendix
206 Front panel Display Rear panel Remote Index