Marantz M-CR611 - Manual (Page 12)

.
GFront panelH
Q6 Q4 Q3 Q5 Q2 Q7 Q1 Q1 Q0
J USB port (T, Front)
Used to connect iPod or USB memory devices. (v p. 26)
K Front panel illumination
Lights when the power is on. The illumination color can be changed/
turned off using “Illumination” in the menu. (v p. 103)
L Standby indicator
The standby indicator changes as shown below according to the status
of the unit.
0
Power on : Off
0
Normal standby : Off
0
iPod charge standby : Red (v p. 56)
0
Display off : Green (v p. 91)
0
Alarm standby : Orange (v p. 100)
0
When “Network Control” is set to “On” : Red (v p. 108)
M
Power operation button (X)
Turns power to this unit on and off (standby). (v p. 35)
0 When “Clock Mode” is turned on, this button switches between normal mode
and Clock mode. (v p. 101)
N Remote control sensor
This receives signals from the remote control unit. (v p. 8)
O Headphones jack (PHONES)
Used to connect headphones.
When the headphones are plugged into this jack, audio will no longer
be output from the speaker terminals, SW OUT connector and AUDIO
OUT connectors.
NOTE
0 To prevent hearing loss, do not raise the volume level excessively when using
headphones.
P
VOLUME up/down buttons (VOLUME df)
Adjusts the volume. (v p. 36)
Q
Stop button (2)
Contents Connections Playback Settings Tips Appendix
12 Front/Top
panel
Rear panel
Remote control
unit
Index