Kreg Precision Miter Gauge System - Manual (Page 8)

Assembly - Swing Stop TM
8.
Assemble the Swing Stop™ with the arm on the blade or bit side of
the base.
! ATTENTION
Swing Stop TM
Parts Diagram
Assemble the stop
Referring to the drawing above, assemble the Swing Stop™. When installing the 5/16"-24 x 3¼" hex head bolt that
joins the arm to the base, tighten the lock nut enough to eliminate side-to-side play but still allow the arm to move
freely. (Raise and release the arm. It should fall slowly.) When installing the lens cursor, position the red line about
⅜" from edge of the arm.
(1) 5/16"-24 x 3¼" hex head bolt
FT4060
(1) Lens
FT4063
(1) Arm
FT4261
(1) ¼"-20 x 1¼" T-bolt
FT4212
(2) 5/16" brass washer
FT4137
(1) #10-32 x ¼" nylon machine screw
FT4064
(4) Fence-stop bushing
FT4257
(1) T-knob
DK1313 (1) 5/16"-24 lock nut
FT4061
(1) Base
FT4262
(1) Support button
FT4258
Blade
Base