Kreg Precision Miter Gauge System - Manual (Page 7)

Assembly - Fence
7.
Slide the heads of two ¼"-20 x 1¼" hex head bolts into the T-slot in the
back of the fence. Insert the bolts into the holes in the face of the miter
gauge head. Thread on the T-knobs. You’ll fi ne-tune the fence position
later.
Attach the fence to the miter-gauge head
Before installing the self-adhesive measuring tape, make sure the
shallow groove in the top of the fence is clean and dry. To hold the
miter gauge steady while you install the tape, place the miter gauge in
the saw miter-gauge slot. Cut the tape at the 1” mark and the 25" mark
using sturdy scissors or metal snips.
Adhere the measuring tape
Peel the backing from the 1" end of the measuring tape, exposing
about one inch of the adhesive. Fold the backing so it protrudes from
the tape at an angle. Align the tape 1” mark with the right-hand end of
the fence (the end nearest to the saw blade) and press the tape into
the shallow groove in the rail. With the fi rst inch of tape adhered, pull
the backing from under the tape, pressing the tape into the groove as
you continue to remove the backing. Should you attach the scale in the
wrong position, immediately remove and reposition it, and then fi rmly
press it in place.