Kreg KKS1060 Klamp Vise - Manual

Attach Plate
English
Locate the spot where you’d like to connect the Klamp Vise™ Plate.
The workbench/workpiece must be at least 1” thick and at most 2”
thick*. It must be sturdy enough to handle considerable clamping
force. Use either the 1” ¼-20 Phillips Pan Head screws for metal
surfaces or the #14 x 1-1/2 Phillips Woodscrews for wood surfaces to
secure the plate in place.
Separate the Plastic Glide Pad from its paper backing. Then, carefully
center and adhere the pad to the base of the Bench Klamp™. Any
part of the pad which extends beyond the Bench Klamp’s base may be
trimmed off, using a pair of scissors. Then, insert the Anchoring Screw
into the base of the Bench Klamp™. Start with the Anchoring Screw
roughly ½ of the way in, and test it on the Klamp Vise™ Plate. If the
connection is too tight, the Bench Klamp™ will not be able to move
freely across the trak. If the connection is too loose, the clamp may
catch as you slide it across the track.
Kreg Bench Dogs are easy to use and
even easier to install. They fit into any
existing ¾” workbench dog hole. If your
bench does not have bench dog holes,
use a ¾” wood spade or brad-point bit
to drill your own. Location of the holes
should vary to accommodate a variety of
workpiece sizes. You may also attach the
optional Bench Brakes™ on top of the
Bench Dogs. These simple rubber pieces
give you a solid slip-free work surface for
sanding, routing, and sawing.
There are a wide variety of practical applications for the Klamp Vise™.
You can use it in traditional vise type applications, vertical clamping,
horizontal clamping, for large workpieces and small. Try the Klamp
Vise™ in conjunction with other Klamp System™ components (including
the Klamp Plate™, Klamp Trak™, Large Bench Klamp™, etc.) for the
best possible clamping solution.
Clamp Setup
For use with: Klamp Vise™ & Klamp Vise™ Plate
À utiliser avec : le Klamp Vise™ et la plaque Klamp Vise™
Para uso con: Klamp Vise™ y Placa Klamp Vise™
Bench Dog Setup
Klamp Blocks
Klamp Blocks™ are designed to help you get the correct workpiece
height when using the Klamp Vise™ for traditional vise-type
applications where your workpiece is in the vertical position. There
are 4 dimensions listed on each Klamp Block™ (1-1/2”, 2”, 2-1/2”, 3”),
which relate to the distance between the edge of the Klamp Block™
and center point where the Bench Klamp™ contacts the workpiece.
After you’ve chosen your Klamp Block™ setting, insert the t-bolt into
the alignment tab opposite the marking (image shown setting for
1-1/2”) and secure it in place using the plastic nut.
1. 2.
3/4”
Wood Metal
www.kregtool.com • 800.447.8638
NK7873
Version 1 - 7/2011
#KKS1050 & #KKS1060
INSTRUCCIONES
Uses
Klamp Vise
™
Instructions
*Benches over 2” thick may require modification.