KIP KIPFold 1000 - Manual (Page 3)

3
Main connection cable
Do not use a different power connector cable, then that delivered.
When replacement of the power supply cable is required because of dam-
age or defect, contact your CE for proper replacement of this power supply
cable.
Mains connection
• Do not use an extension cord to connect the machine.
• The machine must be connected to a grounded socket outlet.
• This machine is not designed for connection to an IT power supply
system. An IT power system is a voltage network in which the neu-
tral wire is not connected to ground.
• When the machine is connected through a wall-socket, place the
machine near a wall-socket that is easily accessible.
Warning
Measures to take in case of an accident
1. If an accident has occurred, the distributor who has been notified
first must immediately take emergency measures to provide relief to
affected persons and to prevent further damage.
2. If a report of a serious accident has been received from a customer,
an on-site evaluation must be carried out quickly and KIP must be
notified.
3. To determine the cause of the accident, conditions and materials
must be recorded through direct on-site checks, in accordance with
instructions issued by KIP.
4. For reports and measures concerning serious accidents, follow the
regulations specified by every distributor.
Disclaimer
These safeguards have been compiled to the best of our knowledge. They are intended as a compact guide
to the safe handling of the product. We reserve the right to revise specification data sheets, as new infor-
mation becomes available. It is the user´s responsibility to determine the suitability of this information for the
adoption of safety precautions as may be necessary. It is the user´s responsibility to contact KIP to ensure
that the specification data sheets are the latest ones issued. If and in so far as limitation of liability is permit-
ted under the applicable laws, we do not accept liability for any inaccuracy that may occur in this infor-
mation.