Manufactured (mobile) home installation, Warning – Kleenmaid LEK37A Version 506066R4 User Manual
Page 16
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
506066
14
Manufactured (Mobile) Home
Installation
The dryer can be installed in a manufactured (mobile)
home by following these instructions:
1. IMPORTANT: Gas dryers MUST be
permanently attached to the floor at the time
of installation. Order No. 526P3 Dryer
Installation Kit for a manufactured (mobile)
home installation. Follow the instructions
supplied with the kit.
2. Venting – Dryer MUST be exhausted to the
outdoors.
●
The dryer can be exhausted to the outdoors
through the back, left, right or bottom panel. Gas
dryers cannot be exhausted out the left side
because of the burner housing.
●
The dryer exhaust duct must be secured to the
mobile home structure.
●
Exhaust ducts MUST NOT be connected with
sheet metal screws or fasteners which extend into
the duct.
●
Exhaust duct must not be connected to any other
duct, vent or chimney.
●
Dryer exhaust duct MUST NOT terminate under
the mobile home.
●
For proper operation, it is important that the dryer
has an ample amount of outside make-up air. The
free area of any opening for the introduction of
outside air must be at least 163 cm
2
(25 in
2
).
●
When exhausting the dryer to the outdoors, the
dryer can be installed with “0” inch clearance at
the sides and rear. Clearance of the duct from
combustible construction must be a minimum of
5.08 cm (2 inches).
●
Venting materials are not supplied with the dryer
(obtain locally).
IMPORTANT: Installation must conform
to the Manufactured Home Construction
and Safety Standards, Title 24 CFR, Part
32-80 or Standard CAN/CSA-Z240 MH.
To reduce the risk of fire and combustion
gas accumulation, the dryer MUST BE
EXHAUSTED TO THE OUTDOORS. Refer to
Section on Dryer Exhaust Requirements.
W047
WARNING
To reduce the risk of fire, the exhaust duct
and weather hood MUST be fabricated of a
material that will not support combustion.
Rigid or flexible metal pipe is recommended
for a clothes dryer.
W048
WARNING