Kleenmaid LEK37A Version 506066R4 - Manual (Page 11)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
9 506066
Installing the Dryer
Step 1: Position and Level the Dryer
For further assistance refer to section on Location
Requirements
.
Install dryer before washer. This allows room for
attaching exhaust duct.
Place the dryer in position, and adjust the legs until the
dryer is level from side to side and front to back.
Figure 3
Step 2: Connect Dryer Exhaust System
For further assistance refer to sections on Location
Requirements
and Dryer Exhaust Requirements.
●
DO NOT use plastic or thin foil ducting.
●
Locate dryer so exhaust duct is as short as possible.
●
Be certain old ducts are cleaned before installing
your new dryer.
●
Use 10.2 cm (4 inch) diameter rigid or flexible
metal duct.
●
The male end of each section of duct must point
away from the dryer.
●
Use as few elbows as possible.
●
Use duct tape or pop-rivets on all duct joints.
●
Ductwork that runs through unheated areas must
be insulated to help reduce condensation and lint
build-up on pipe walls.
●
Install backdraft dampers in multi-dryer
installations.
IMPORTANT: Failure to exhaust dryer properly
will void warranty.
Figure 4
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
D669I
1 Dryer Base
2 Level
3 Leveling Leg
D669I
D259I
1
2
3
D314I D315I
A clothes dryer produces combustible lint.
To reduce the risk of fire and combustion
gas accumulation the dryer MUST be
exhausted to the outdoors.
W116
WARNING
DO
DON’T