Directed Electronics Nissan - Manual (Page 33)

29 © 2 0 0 6 d i r e c t e d e l e c t r o n i c s
Locate the factory alarm disarm wire using the web site vehicle
information. Once the suspect wire is located, place the LED
tester red lead to a (+)12 volt constant source and secure it.
Then probe the suspect wire . While probing the wire, place
the key in the drivers door cylinder. Turn it to the unlock posi-
tion and hold it when testing for the disarm wire. The LED
tester should illuminate Green and will extinguish when the
key is released.
When the correct wire has been found, solder the LIGHT
GREEN/BLACK (H1/1) wire to the wire which activates in the
unlock position when the key is turned. After this wire has been
connected wrap the connection with electrical tape.
note: On some vehicles the Factory Alarm Disarm wire is
connected to a Body Control Module or a Door Module.
If you find this configuration, please call READY
REMOTE Technical Support at 1
1--8 80 00 0--4 47 77 7--1 13 38 82 2.
G21994_04-06.qxd 12/11/06 3:36 PM Page 29