Kleenmaid ICK98X - Manual (Page 28)

28
Discoloration is caused by pan abrasion or the use
of unsuitable cleaning agents. This is very difficult
to remove. Use Hob Clean or Sidol for ceran + steel.
Our afterĆsales service can remove discoloration,
but will charge for this service.
Always keep the control panels clean and dry.
Food residues and spills can impair the function of
the control panels.
Only use warm soapy water.
Do not use anything which is sharp or abrasive.
The glass scraper is unsuitable. The hob surround
could be damaged.
Neither lemon juice nor vinegar should be used
for cleaning the hob surround.
This could result in matt patches.
Procedure in the event of a malfunction
Malfunctions often have simple explanations and may
be easily rectified. Please read the following
instructions before calling the afterĆsales service.
Make sure that the power draw of all the appliances
switched on does not exceed your maximum
household electricity supply. Check whether
the circuit breaker triggers when you switch on
another hotplate.
The control panel is very dirty, food has been spilt
or an object has been placed on the work surface.
Clean the control panel thoroughly or remove the
object from the work surface. Press the control panel
concerned. The flashing stops.
The main switch was touched inadvertently.
Switch the hob back on. Adjust the settings again.
Shimmering metallic
discoloration
Control panels
Cleaning the hob
surround
The circuit breaker in your
household electrical circuit
trips when you switch on
the hob
E is flashing in all the
hotplate displays and a
signal is sounding
The hob has switched itself
off