Kleenmaid CH24 - Manual (Page 9)

• 9 •
✓ Check that the electricity is switched on to allow
spark ignition.
✓ Make sure that all controls are turned to zero.
✓ The gas flow to the burner is controlled by a knob
operating on a safety tap. You control the flow by
turning the knob indicator to line up with the following
symbols:
symbol ● : Off
symbol : full on (nominal rate)
symbol : reduced rate
✓ To ignite automatically, simply push the required knob
down and turn it to maximum, then press ignition
continuously until the burner lights. When the flame is
lit, you can control the temperature by the knob.
✓ To switch off, turn the knob clockwise until you hear
the safety click.
✓ Note that, if you are using a burner at the minimum
setting, you turn the knob clockwise past the maximum
setting before reaching the off position.
COOKING HINTS FOR GAS HOBS
✓ The burners are different sizes, and can be used in
different ways.
✓ The largest can be used for boiling, to seal meat or
foods that are cooked quickly, and the smallest for
stews and sauces.
✓ Always ensure that you use the correct size of
saucepan.
✓ For fast boiling, make sure the flame just reaches the
edge of the pan. Flames going up the side of the pan
means wasted heat and the contents of the pan will
take longer to boil.
Figure 13
CORRECT USE OF DOUBLE-RING
BURNER
✓ The flat-bottomed pans are to be placed directly onto
the pan-support.
✓ To use the WOK you need to place the proper stand
in order to avoid any faulty operation of the wok
burner.
WRONG
Figure 14
Figure 15
CORRECT
To ignite the burners with flame failure device:
1. Turn the knob counter-clockwise to the “full on” position,
then maintain this pressure
2. Press ignition continuously until the burner lights.
3. Wait for about 10 seconds after the gas burner has been lit
before letting go of the knob (security valve activation
delay)
4. You can control the temperature by the knob.
If the burner flame should go out for same reason, the safety
valve will automatically stop the gas flow.