Kleenmaid CH24 - Manual (Page 4)

• 4 •
DIMENSIONS (Table 3):
Models: CH35 - CH95S
(Note: Also refer to Figure 3 side)
General Dimensions
Width
860 mm
Depth 500 mm
Depth Below Mounting Surface 30 mm
Cut-out Dimensions
Width
840 mm
Depth 480 mm
Figure 3
General Dimensions
Width
580 mm
Depth 500 mm
Depth Below Mounting Surface 30 mm
Cut-out Dimensions
Width
560 mm
Depth 480 mm
560
580
500
480
50
Figure 2
The installation shall comply with the dimensions in
Figures 2 and 3, bearing in mind that:
✓ A minimum clearance of 20 mm has to be kept
between the bottom of the cooking hob and the top
of an appliance or a shelf.
✓ A partition between the base of the hob and the
cupboard below should be fitted 100 mm below the
workbench surface if the cupboard is to be used for
storage.
✓ Overhead clearances - In no case shall the clearance
between the highest part of the hob and a range hood
be less than 600 mm, or for an overhead exhaust fan,
750 mm. Any other downward facing combustible
surface less than 600 mm above the highest part of the
hob shall be protected for the full width and depth of
the cooking surface area in accordance with Clause
5.12.1.2 of AG 601. However, in no case shall this
clearance to any surface be less than 450 mm.
✓ Side clearances - Where the dimension from the
periphery of the nearest burner to any vertical
combustible surface is less than 200 mm, the surface
shall be protected in accordance with Clause 5.12.1.2
of AG 601 to a height of not less than 150 mm above
the hob for the full dimension (width or depth) of the
cooking surface area.
✓ Protection of combustible surfaces - AG 601 Clause
5.12.1.2 specifies that where required protection shall
ensure that the surface temperature of the combustible
surface does not exceed 50 °C above ambient. The
fixing of 5 mm thick ceramic tiles to the surface or
attaching fire resistant material to the surface and
covering with sheet metal with minimum thickness of
0.4 mm would satisfy this requirement.
DIMENSIONS (Table 2):
Models: CH24 - CH25 - CH26
CH84W - CH85S - CH86B
(Note: Also refer to Figure 2 side)