Kemppi KempArc DT400 - Manual (Page 8)

EN
2. use
2.1 pOWer sOurCe
2.1.1 power source components
A10
A1
A2
A4
A6
A11
A5
A7
A9
A8
A3
1 2 3 4
A1 Control panel
A2 Main switch
A3 Signal light (I/O)
A4 Thermal warning light
A5 Welding cable connection (parallel)
A6 Earthing cable connection
A7 Control cable connection (parallel)
A8 Mains cable
A9 Fuse for control cable connection (6.3 A slow)
A10 Fan grill
A11 Transportation handles
2.1.2 locating the power source
Place the machine on a sturdy, level surface that is dry and does not release dust or other
impurities to the suction air through the fan grill.
Notes for positioning of the machine
• Preferably, place the machine somewhat above floor level.
• The surface inclination may not exceed 15 degrees.
• There must be at least 20 cm of free space in front of and behind the machine for cooling
air circulation.
• Protect the machine against heavy rain and direct sunshine.
• Ensure the free circulation of the cooling air.
The protection class of the machine, IP23C, allows water spray to hit the machine’s outer
covering at a maximum angle of 60 degrees.
NOTE! Never aim the spray of sparks from a grinding machine toward the power source.
KempA
rc
SY
N
300,
400,
500
/
©
Kemppi
O
y
/ 0808
FI
SV
NO
DA
EN
DE
NL
FR
ES
PL
RU
1 Robot Control
2 Wire Feeder
3 Throughput
4 Analog