Kemppi KempArc DT400 - Manual (Page 17)

EN
2.2.11 synergetic 1-mig welding and AAA-mig welding
In synergetic 1-MIG welding, the machine selects the optimal welding parameters suitable to
the filler wire and shield gas using the programs, or synergetic curves, stored in the control
panel. The welder controls the welding by adjusting the welding power and arc length.
The synergetic AAA-MIG process (advanced auto arc) is a synergetic welding process
developed for the special needs of robotic welding with weldig characteristics optimised
particularly for welding automation.
selecting a welding program
1. Before you start welding, find the welding program suitable to your filler wire and shield
gas in the tables below and then activate the program as follows:
2. Press the SYNERGIC PROGRAM button P7 for more than 1 second. This will activate
program selection and the control panel displays start flashing.
3. Select the material group with the left-hand side control knob and the welding program
for the material group with the right-hand side control knob according to the tables
below. The program you selected is immediately recorded in the memory.
4. Press ESC button or the SYNERGIC PROGRAM button P7 to exit the menu.
mig programs in the KempArc™ sYn machine
1-MIG, Fe group
Program number Wire, mm Material Shield gas
101 0,8 Fe Ar+18%-25%CO2
102 0,9 Fe Ar+18%-25%CO2
103 1,0 Fe Ar+18%-25%CO2
104 1,2 Fe Ar+18%-25%CO2
106 1,6 Fe Ar+18%-25%CO2
111 0,8 Fe CO2
112 0,9 Fe CO2
113 1,0 Fe CO2
114 1,2 Fe CO2
116 1,6 Fe CO2
121 0,8 Fe Ar+8%CO2
122 0,9 Fe Ar+8%CO2
123 1,0 Fe Ar+8%CO2
124 1,2 Fe Ar+8%CO2
126 1,6 Fe Ar+8%CO2
152 0,9 FEMC Ar+18%-25%CO2
154 1,2 FEMC Ar+18%-25%CO2
164 1,2 FEMC CO2
174 1,2 FEFC rutile Ar+18%-25%CO2
184 1,2 FEFC rutile CO2
194 1,2 FEFC basic Ar+18%-25%CO2
1
KempA
rc
SY
N
300,
400,
500
/
©
Kemppi
O
y
/ 0808
FI
SV
NO
DA
EN
DE
NL
FR
ES
PL
RU