Kemppi Evo 300 - Manual (Page 6)

FitWeld Evo 300
4
EN
2. using the maChine
2.1 Before use
The product is packed in cartons designed specifically for them. However, always make sure
before use that the products have not been damaged during transportation.
Check also that you have received the components you ordered and the instruction manuals
needed, as described in the Quick start guide. Product packaging material is recyclable.
Please also read the Safety Instructions included with the package before use.
NOTE! When moving the welding machine, always lift it from the handle, never pull it from the
welding gun or other cables.
Operating environment
This machine is suitable for both indoor and outdoor use. Always make sure that the air flow in
the machine is unrestricted. The recommended operating temperature range is -20 ... +40 °C.
2.2 machine introduction
1.
2.
3.
4.
5
.
6
.
7.
1. ON/OFF
2. Mains supply cable
3. Earth return cable
4. Shielding gas connector
5. EURO gun connector
6. Meter displays
7. Control knobs
2.3 distribution network
All regular electrical devices without special circuits generate harmonic currents into
distribution network. High rates of harmonic current may cause losses and disturbance to
some equipment.
This equipment complies with IEC 61000-3-12 provided that the short-circuit power Ssc
is greater than or equal to 1.9 MVA at the interface point between the user’s supply and
the public supply network. It is the responsibility of the installer or user of the equipment
to ensure, by consultation with the distribution network operator if necessary, that the
equipment is connected only to a supply with a short-circuit power Ssc greater than or equal
to 1.9 MVA.
2.4 Connecting cables
Before you can start welding with FitWeld Evo 300, you must connect the machine to the
mains power supply, attach the welding gun and the earth return cable and the shielding
gas supply. You must also equip the machine with a filler wire spool suitable for your welding
application.