Kemppi Evo 300 - Manual (Page 13)

11
© Kemppi Oy / 1515
EN
2.6 Controlling welding functions
With FitWeld Evo 300 you can easily control welding parameters, change the welding polarity
and gun operating mode.
The control panel provides two adjustment knobs. You can set the desired welding voltage
and wire feed speed before or during welding, so easily tuning the desired arc performance to
the weld.
2.6.1 Control panel functions
10
9
8
7
6 5
4
3
2
1 10
9
8
7
6 5
4
3
2
1
U
ON
W003793
FitWeld
With the left-hand control knob, set the value for filler wire feed speed. The maximum value is
18 meters per minute.
With the right-hand control knob, set the welding voltage. Adjustment range is from 11V to
32V.
The leds on the front panel indicate the following (from top to bottom):
• Machine is turned on
• Machine is overheated
• Error in shielding gas flow
U
I A
m
min
V
The leds on the right hand side of the upper meter display indicate the showed variable, either
A or m/min. When not welding, the meter displays will show the selected wire feed speed
and voltage. When welding, the meter displays will show the actual current and voltage.
The parameters can be adjusted during welding and the meter displays will show the new
selected value. After welding the meter displays will briefly show an average value of the
actual current and voltage.