Kemppi MSF 53 - Manual (Page 23)

EN
Cable Compensation CAL -5.0 ... 9.0
V/100 A (1.0 V/100 A) Cable compensation (MIG)
for voltage drop
NOTE! In crater fill, the initial value of the welding power must be greater than the final value,
and therefore the adjustment ranges for the initial and final values are restricted automatically, if
necessary.
Welding Level
Crater Fill Start Level
Crater Fill Time
Crater Fill End Level
WiseRoot
Name of parameter
Name on
display
Parameter
values
Factory setting Description
Start Time FSt -9 ... +9 (0) Start time duration in WiseRoot process
(maximum is 3 seconds)
Start Voltage Level FuL -30 ... +30 (0) Voltage level of the start phase.
Common SETUP-parametres for MIG-processes (only SF53, SF55)
Name of parameter
Name on
display
Parameter
values
Factory setting Description
Device Address Add 3 or 6 (3) Wire feeder bus address
Using features of PMT
Gun
Gun OFF, on (on) on = PMT gun
OFF = other gun
Gas Guard Connected GG no, yES (no) yES = gas guard connected
no = gas guard not connected
LongSystem Mode LSy on, OFF (OFF) Choose position ‘on’ when using long
distance interconnection cable (>40 m)
Code Entry Cod ---, Ent (---) Programming extra values,
see page 18
PIN Code Entry PIn ---, Ent (---) PIN code selection
(requires MatchPIN activation)
Panel Locking LoC on, OFF (OFF) Panel lock on/off
(requires MatchPIN activation)
Restore Factory
Settings
FAC OFF, PAn, All (OFF) Restores factory settings when ’on’ is
selected, exit SETUP mode
Each welding process has got SETUP-parameters of it’s own. For instance synergig MIG post
gas time has got no effect on normal MIG post gas time.
The value of the parameter is immediately recorded in the memory. Exit SETUP mode by
holding down the new SETUP button or by briefly pressing the ON/OFF button.
21
FastM
ig MSF 53, 55, 57 / © Kemppi O
y / 1515