Kemppi MSF 53 - Manual (Page 22)

EN
3.3 SETUP FUNCTIONS (10)
The unit is equipped with a number of functions that can be selected. Parameters can be set
via the SETUP function. The SETUP function is activated by pressing the SETUP button (10)
for >1 second. The adjustable parameter is selected via the left-hand potentiometer (14), the
name of which is shown on display No. 2. The value of the parameter in question is adjusted
via the right-hand potentiometer (16), the value of which is shown on the display (8). The
parameters and their possible values are:
Normal MIG -welding SETUP -parametres
Name of parameter Name on
display
Parameter values Factory setting Description
Pre Gas Time PrG 0.0...9.9 s 0,0 s Pre gas time in seconds
Post Gas Time PoG 0.1 ... 32.0 s Aut Post gas time in seconds or
automatically according to welding
current (Aut)
Creep Start Level CrE 10...170% 50 % Percentage of wire feed speed:
10 % slowed start
100 % = no creep start function
170 % accelerated start
Start Power StA -9 … +9 (0) Strength of start pulse
Post Current Time PoC -9 ... +9 0 Post current
Set Voltage Limit U2L 25.0 ... 48.0 V 37.0 (300)
39.0 (400)
42.0 (500) Maximum value for MIG voltage setting
Synergic MIG -welding SETUP -parametres
Name of parameter
Name on
display
Parameter
values
Factory setting Description
Pre Gas Time PrG 0.0...9.9 s (Syn) Pre gas time in seconds or automatically
according to synergic welding program (Syn)
Post Gas Time PoG 0.0...9.9 s (Syn) Post gas time in seconds or automatically
according to synergic welding program (Syn)
Creep Start Level Cre 10 ... 170 % (50 %) Percentage of wire feed speed:
10 % slowed start
100 % = no creep start function
170 % accelerated start
Hot Start Level Hot -50 ... 75 % (30 %) Percentage of welding power:
-50 % cold and +75 % hot
Hot Start 2T Time H2t 0.0 ... 9.9 s (1.2 s) The duration of the hot start in seconds in 2T
mode
Crater Fill Start Level CrS 10 ... 250 % (30 %) The welding power at the beginning of the
crater fill stage as a percentage of the welding
power preset value
Crater Fill Time CrT 0.0 ... 9.9 s (2.0 s) The duration of the crater fill stage in seconds
(only in 2T mode)
Crater Fill End Level CrL 10 ... 250 % (30 %) The welding power at the end of the crater fill
stage as a percentage of the welding power
preset value
Start Power StA -9 ... +9 (0) Strength of start pulse
Post Current Time PoC -9 ... +9 (0) Post current
Synergic MIG Unit Unl mm, m/
min, A (m/min) In 1-MIG and WiseRoot welding, the parameter
shown in left-hand display: sheet thickness
(mm), wire feed speed (m/min) or average
current (A)
20
FastM
ig MSF 53, 55, 57 / © Kemppi O
y / 1515